A strongly alkaline concentrate (pH approx. 12.5) for organic and greasy soiling. Used only after dilution - 1:5 to 1:1, most often 1:4. Consumption approx. 0.1-0.3 l per m².
Surface
Concrete and floors
The surface the manufacturer intends this preparation for.
D-12 is a strongly alkaline concentrate (pH approx. 12.5) for organic and greasy soiling that a routine cleaner from the C range will not shift.
The manufacturer gives one rule without exceptions: do not use undiluted. The range is 1:5 to 1:1, most often 1:4. Consumption approx. 0.1-0.3 l of working solution per square metre.
Before starting, mask anything that is not being cleaned - the manufacturer suggests covers of absorbent material, polyurethane sponge or wiping cloth.
The usual reason a sealing job fails is not the product but the substrate. A sealer will not bond to a surface with grease, lime efflorescence or an old coating on it.
New paving has to season first. Manufacturers state that period on the data sheet - usually around 28 days from the date the block was made. The figure for each product is under "Technical data".
Before sealing the whole area, test on a patch hidden by a planter or in a corner of the patio. The same product can read differently on two batches of the same material, and on a surface with old coating left on it, it will not bond at all.
That depends on the finish given in the technical data. An invisible product leaves the colour alone, a wet-look version deepens it permanently, and a colour sealer gives it a new shade. Each product's finish is listed under "Technical data".
By how the water behaves. While it still beads on the surface, the treatment is working. Once water starts soaking in and dark patches return after rain, the protection has worn out. We do not quote a number of years, because it depends on traffic, sun and whether the drive is salted in winter.
No. Water occupies the pores the product is meant to enter, and stays trapped under the film. The result is often a milky bloom that cannot be removed without stripping the coat. The exceptions - products that allow slight surface dampness - say so in their technical data.
Use the calculator under the product description: it takes the manufacturer's coverage figure, the number of coats and the absorbency of the substrate, and turns them into pack sizes. On older, thirstier paving, work to the lower end of the coverage range.
Penetrating products form no film on the surface and do not change its grip. Where a manufacturer says something about slipperiness, we quote it in the technical data. If the surface is already slippery, the right product is an anti-slip treatment, not a sealer.
A 1:4 dilution means one part product to four parts water - a litre of concentrate gives five litres of working solution. Where the ratio is given in ml per litre of water (the C range), work the other way: 50 ml per litre means 20 litres of solution from one litre of concentrate.
The same chemistry for two uses. D-12 is the general product for heavy organic soiling. D-12K is the one the manufacturer tested and documented for block paving, with working conditions added: up to 30 °C and 85 % humidity.
pH 12.5 as a concentrate is aggressive both to the substrate and to the user. The manufacturer rules that use out explicitly - it is a condition of use, not a recommendation.
The technical sheet and safety data sheet will be available after approval.
This product has no stated coverage yet, so we cannot work out the requirement.
The calculator starts once the manufacturer states the coverage.
Go directly to the right category. We do not imply compatibility across materials.